Thank You for visiting our web site ComiPack LLC.

MC-12

MC-12 Economy: 

  • Volumetric dosing principle
  • RPM adjustment, additive feeder
  • Low investment, high savings
  • Accurate and reliable, 5 years warranty

MC-12 controls were designed to set metering speed and metering time manually. The unit also works in relay mode for extrusion applications. Unlike the MC-18 the MC-12 features manual voltage adjustment in combination with a standard 115/230 VAC transformer.

 

  • Service Centre of  Movacolor
  • consulting 

 

Output Ranges
Dosing system Dosing
capacity
gram/sec
Dosing capacity
Kg/hour
Type GL* 0.02 to 0.4 0.07 to 1.44
Type G* 0.2 to 7 0.72 to 25.2

Note* measured with granular masterbatch 0.8 kg/dm³

 

Calibration Method/ControlsThe required metering system rpm needs to be tested by manual deduction. When testing off-line the TEST button will run the unit at the set parameters. The measured value needs to be re-evaluated with the required set point. When required metering speed must be adjusted. This procedure is repeated until the required set point is achieved.

 

Controls
Speed: Manual setting from 0 to 200 rpm max, in increments of 0.1 rpm.
Time: Manual setting from 0 to 999 sec in increments of 0.1 sec.
Keyboard lock: 1 level.

 

Monitoring/System Information/ External communication4-piece 7 segments LED at front display.
Man/machine interface: keypad.
External communication: none.
Alarm: LED indication, 1 external alarm.

 

Specifications/Standards & DirectivesTechnical data:
Manual mains power selector 110/230 VAC 50 - 60 Hz.
Power consumed 50 Watt.
Stepper motor (1.8 degr/step) max 2 Amp at 40 Volt.
Operating Temperature: -20 to + 70 degr. C.

Input signal(s):
Injection molding:
Start/stop trigger input, potential free or 0 -24 VDC.

Extrusion:
Start/stop trigger input, potential free or 0 -24 VDC.

Output(s):
- Stepper motor max output 2 A (40 VDC).

 


© 2011 Comipack
E-mail:  info@comipack.net
Telephone: +7(495) 737-67-60, +7(495) 589-05-93, +7(926) 182-83-28
Address: Moscow